Dee Zee DZ43301 - Manual

FOR INSTALLATION ON DRIVER'S SIDE ONLY
PARTS LIST:
ITEM QTY
THREAD LOCK TUBE 1
SHOCK 1
BALL MOUNT PLATE 1
NUTSERT TOOL 1
BALL MOUNT 1
NUTSERT 1
TORX WRENCH 1
CABLE CLIP 1
TOOLS REQUIRED:
T-45 TORX
M5 ALLEN WRENCH
TAPE MEASURE
10MM WRENCH
13MM WRENCH/SOCKET
NOTE: THIS PRODUCT CAN ONLY STEP 2) STEP 3)
BE INSTALLED ON THE Using a M5 Allen wrench and Mark one side of the nut and Apply thread lock to the threads
DRIVER'S SIDE. a 10mm wrench, install the count the number of revolutions of the ball mount.
nutsert in the opening by the to insure the correct number Install the ball mount into the
STEP 1) tailgate pivot point of full turns. nutsert using a 13mm
Adjust the nutsert tool so Overtightening the nutsert wrench/socket.
there is 3/4" from the washer can strip the threads and cause Torque to 8 ft-lbs with
to the head of the bolt. the nutsert to be unusable. 13mm socket.
Remove the nutsert tool
when installation is complete.
The nutsert should be tightened 9
360 degree turns.
DZ 43301
DODGE RAM TAILGATE ASSIST
1500 2009- CURRENT
2500/3500 2010 - CURRENT
DO NOT TURN
DZ 43301 9/25/2013