Dee Zee DZ43203 - Manual (Page 2)

FOR INSTALLATION ON DRIVER'S SIDE ONLY
STEP 4) STEP 5) STEP 6) STEP 7)
Use a T50 torx socket or the Install the bolt removed from Install the cable back onto Install the narrow end of the
wrench provided to remove the the previous step through the the cable bolt, and the shock on the ball mount
cable bolt. Remove the tailgate hole in the ball mount plate back larger part of the shock previously installed.
cable from the bolt. into the hole. on the ball mount.
Tighten the bolt with the T50.
STEP 8) Inside the taillight opening ,
use an 11mm socket to remove the
2 nuts holding the rubber block
in place.
Using a 8mm wrench/socket,
remove the 2 bolts holding the
taillight in palce.
There will still be 2 clips
holding the taillight in place.
After removing the rubber block
Pull the taillight towards the reinstall the taillight.
rear of the vehicle to remove, If the rubber block is not removed,
it will interfere with the shock.
DZ 43203 9/25/2013