Dee Zee DZ43203 - Manual

FOR INSTALLATION ON DRIVER'S SIDE ONLY
PARTS LIST:
ITEM QTY
THREAD LOCK TUBE 1
SHOCK 1
BALL MOUNT PLATE 1
NUTSERT TOOL 1
BALL MOUNT 1
NUTSERT 1
TORX WRENCH 1
TOOLS REQUIRED:
T-50 TORX
M6 ALLEN WRENCH
16MM WRENCH
13MM WRENCH
TAPE MEASURE
16MM DEEPWELL SOCKET
SUPERDUTY ONLY
8MM WRENCH
11MM WRENCH
NOTE: THIS PRODUCT CAN ONLY STEP 2) STEP 3)
BE INSTALLED ON THE Using a M6 Allen wrench and Mark one side of the nut and Apply thread lock to the
DRIVER'S SIDE. a 13mm wrench, install the count the number of revolutions threads of the ball mount.
nutsert in the opening by the to insure the correct number Install the ball mount into the
STEP 1) tailgate pivot point. of full turns. nutsert using a 16mm
Adjust the nutsert tool so Overtightening the nutsert wrench/socket.
there is 3/4" from the washer can strip the threads and cause Torgue to 12 ft-lbs
to the head of the bolt. the nutsert to be unusable. with 16mm deepwell socket
Remove the nutsert tool
when installation is complete.
The nutsert should be tightened 9
360 degree turns.
DZ 43203
TAILGATE ASSIST
FORD F-150 1997-2003
SUPERDUTY 1999-2011
DO NOT TURN
DZ 43203 9/25/2013