Dee Zee DZ950531B - Manual (Page 4)

Place the large 3/8" washer [E] onto the 3/8"-3 1/2" allen bolt. Then put the bolt through the slot
in the brace, through both holes in the rubber mount block [G], and thread it into
the threaded plate. Do not tighten completely.
2
THE LOCATION OF THIS SLOT WILL VARY
DEPENDING ON WHAT VEHICLE THE CAB RACK IS
BEING INSTALLED ON. THIS DRAWING MAY VARY
FROM THE ACTUAL BRACKET YOU HAVE.
Insert the rubber block into the front stake pocket hole.
For Dodge stake holes, it will be necessary to
leave a gap between the plate and the rubber block.
You will need to insert one end of the plate and
move the bolt towards the end of the stake pocket
to allow the other end of the plate to go in.
The rubber block can then be put into the
stake pocket.
INSERT RUBBER BLOCK INTO
STAKE POCKET
GAP
PS STEEL CAB RACK BKT 3 OF 7 10/12/2011