Dee Zee RAM-VB-178-SW1 - Manual (Page 2)

National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [email protected]
Vehicle base for the
INSTALLATION INSTRUCTIONS
Tools needed are a socket wrench with extension, 15MM socket, 13MM socket.
Note that on some trim levels a plastic cover blocks access to the outermost seat leg bolt. This cover has to be
removed and stored for installation into Crew or Quad cab models. It can be put back in place after installation on
standard cab models.
Regular and extended cab models:
1. Move the passenger seat back to its rear-most position and remove the two front seat rail bolts on the passenger
side using the 15MM socket. These pass through the seat frame legs into the floor board.
2. Without moving the seat, place the No-Drill
TM
base over the front of the seat frame legs.
3. Align the holes in the base with those of the seat frame legs. The pedestal platform should be near the console.
4. Re-install the seat bolts and fully tighten.
Crew or quad cab models with under seat air duct:
1. Move the passenger seat back to its rearmost position and remove the two front seat rail bolts on the passenger side
using the 15MM socket. Store these so that they can be reinstalled should the laptop stand be removed later.
2. This kit comes with 2 small stand offs shaped like short sections of pipe, two longer seat leg bolts, and two flat
washers. Pass the bolts through the flat washers and then each through the holes on the no drill base.
3. Place the stand off over the hole in the seat frame leg. The stand off goes in between the seat frame leg and the no
drill base providing a gap to clear the under seat air duct in some vehicle models.
4. With the stand off in place and the bolt now passing through the stand off, start the thread by hand on each bolt.
5. Once the bolt is started, use the 13MM socket to fully tighten the seat leg bolt.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
TM
Seat Bases
National Products, Inc.
Item Number
RAM-VB-178
DODGE RAM 1500 to 5500 TRUCKS
(2008-NEWER)