Dee Zee DZ17941 - Manual (Page 4)

.
Mudflap Installation:
1) Place the mudflap up to the wheel well and use the holes in the mudflap as a guide
to center punch and mark the mounting holes on the fender well. (Note: There are no holes
in the lower part of the attachment flange of the Mudflap. This will have to be drilled.)
2) Using a 1/8” Drill bit and drill, drill a hole in the three locations
3) Now secure the mudflap to the wheel well using the #8 x 3/4” phillips head screws (B) and a
1/4” Flat Washer (C). Tighten into place using a short phillips head screwdriver.
(Note: The screws have a wax coating that when installed, will seal the holes in the vehicle.)
2
B C
Use holes in Mudflap as
a guide for drilling holes.
Drill hole in Mudflap and
wheel well. (Note: there
is no existing hole in the
Mudflap in this location.)
Align Mudflap on the truck