Dee Zee DZ2034 - Manual (Page 6)

Page 6 of 9
DZ 2034 04/17/08
Place an 8mm U-clip (G) onto the rocker panel bracket (C) as shown below.
4a-Place the rocker panel bracket up to the 8mm U-clips installed into the rocker panel and
secure into place using the 8mm X 25mm hex flange bolts (H). Secure the bottom of the
rocker panel bracket to the bottom of the rocker panel using 8mm x 25mm hex flange bolts
(H). Tighten into place using a 13mm wrench / or socket.
4b – Use the bottom hole in the Rocker Panel Bracket (C) as a guide to drill a 3/16” hole
through the inside of the rocker panel. Secure the bottom of the rocker panel bracket to the
rocker panel using the 8mm U-clips installed into the rocker panel and secure into place using
the 8mm X 25mm hex flange bolts (H)
3
4a
3/16” DRILL BIT