Dee Zee DZ16260 - Manual (Page 4)

WRENCH/RATCHET
10mm, 13mm
TAPE
MEASURE
SCREWDRIVER
TIN SNIPS
There are three brace mounting location on each side of the vehicle.
Locate the clips that attach the plastic cover to the vehicle. These will be located just inside the
pinch weld on the vehicle. There will either be 2 or 3 clips on the driver's side depending on what
model year vehicle you have. There will be 3 clips on the passenger side.
Using a 10mm socket, remove the bolt from the clip, and slide the plastic cover out of the clip.
If your vehicle only has 2 clips on the driver's side, the front mounting location for the plastic cover
will be attached with a bolt through the cover and into a metal bracket. Remove this bolt, but
do not discard it. It will be used to reattach the plastic cover.
TOOLS REQUIRED
1
CLIP
FRONT BOLT
BRACKET
DZ 16260 2 OF 13 1/30/2014