Dee Zee DZ16253 - Manual (Page 7)

Put the threaded plate into the hole where the 2nd rubber plug was removed.
Once the threaded plate is in the hole, attach the rear mounting hole in the brace with
an 8mm bolt [H] into the nutsert installed in a previous step.
Thread the 8mm bolt in until it is hand tight.
Pull down on the front part of the brace to put tension on the threaded plate that is in the
rocker panel hole. Tighten the 6mm bolt using a 10mm socket.
Torque the 8mm bolt to 10 ft-lbs. Torque the 6mm bolt to 8 ft-lbs.
6
TIGHTEN BOLT
HERE
PULL
BRACE
DOWN
DZ 16253 5 OF 9 7/31/2013