Dee Zee DZ16253 - Manual (Page 6)

Using a 13 wrench and a 6mm allen socket, tighten
the nutsert into place. This is done by holding the
6mm allen wrench/socket stationary and turning the
with the 13mm wrench clockwise. It will take between
nine and twelve 360 degree turns to tightenthe nutsert.
Be careful not to overtighten the nutsert as this will
strip the threads.
Using the 6mm bolt [I] and threaded plate [J], thread the bolt into the plate in the front mounting
hole in the driver side front brace [D].
Only thread the bolt into the plate 3-4 turns.
4
5
13mm WRENCH
6mm ALLEN
DZ 16253 4 OF 9 7/31/2013