Dee Zee DZ16213 - Manual (Page 5)

Place an 8mm x 20mm hex head bolt [E] through the brace [D] and thread the bolt into a large
threaded plate [D] in the slot as shown below. Then place two 8mm x 20mm hex head bolts [E] through
the holes in the brace and thread them into two single tab weld nuts [G] as shown below.
Repeat this step for all of the braces.
Position the brace into the front & rear
locations with the weld nuts in the
vehicle openings.
Pull down or back on the brace to
put tension on the threaded plates in
the holes and tighten the bolts with
a 13mm socket/ratchet.
2
WHEN THREADING BOLT INTO
PLATE [G], MAKE SURE THE
RAISED EDGE IS TOWARDS THE
BOLT.
DZ 16213 3 of 5 6/13/2013