Dee Zee DZ372299 - Manual (Page 2)

3"/4" BENT END SIDEBARS
09-11 FORD F-150 REGULAR AND SUPERCAB
Page 1 of 5 11/19/08 (DP)
PARTS LIST:
1 Driver/Left Sidebar 4 1/2” Lock Washers
1 Passenger/Right Sidebar 4 12mm x 32mm OD x 3mm Flat Washers
1 Driver/Left Front Mounting Bracket 4 12mm Lock Washers
1 Passenger/Right Front Mounting Bracket 4 12mm Hex Nuts
2 Support Brackets 4 10-1.50mm x 30mm Hex Bolts
1 Driver/Left Top Mounting Bracket 4 10-1.50mm x 35mm Hex Bolts
1 Passenger/Right Top Mounting Bracket 6 10mm x 30mm OD x 2.5mm Flat Washers
1 Driver/Left Rear Mounting Bracket 8 10mm x 20mm OD x 2mm Flat Washers
1 Passenger/Right Rear Mounting Bracket 8 10mm Lock Washers
2 12mm x 40mm x 10mm Nut and Bolt Plate 6 10mm Hex Nuts
2 12mm x 40mm Bolt Plates 4 8-1.25mm x 30mm Hex Bolts
4 12mm Plastic Retainers 4 8mm x 24mm OD x 2mm Flat Washers (Outer)
2 10mm Plastic Retainers 4 8mm x 16mm OD x 1.6mm Flat Washers (Inner)
4 1/2" x 2” Hex Bolts 4 8mm Lock Washers
4 1/2” x 1-1/4” OD x 3/32” Flat Washers 4 8mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DRILLING MAY BE
REQUIRED. ASSISTANCE RECOMMENDED.
2. Starting at the front of the driver side of the vehicle, remove the two small hex bolts and the
metal clips holding the bottom of the fender to the body, (Figure 1A). NOTE: Use a small flat
screwdriver to spread the clip apart for easy removal. Due to body panel misalignment from
the factory, it may be necessary to open these holes slightly with a 3/8" drill bit, (Figure 1B).
Passenger/Right
Front Mounting
Bracket
Passenger/Right
Rear Mounting
Bracket
12mm x 40mm x 10mm
Nut and Bolt Plate
12mm x 40mm Bolt Plate
Passenger/Right
Top Bracket
Drive/Left
Top Bracket
(2) Front Support
Straps
Driver/Left Rear
Mounting Bracket
Driver/Left
Front
Mounting
Bracket
Passenger Sidebar illustrated
Front