Monoprice 6531 MHP-52 - Manual (Page 7)

7 of 8
Mounting the Assembly Adapter Plate to screen
Modify the Adapter Plate
Adaptor Modify the Assembled Adapter Plate
Slide the adapter brackets into Assembled adapter plate slightly.
Place the
Assembled Adapter Plate on the back of the display with
one Adapter Bracket aligned with a set of vertical mounting
holes.Then,slide the other Adapter Bracket in or out until it aligns
with the second set of vertical mounting holes.The Adapter should
be horizontally centered on the back of the flat panel displa
y.
Adaptor and hooks Use four M6x12 screws and four washers
and tighten it with Phillips Head Screw Driver.
Adapter
Bracket
Adaptor and hooks
Back of Screen
Adaptor and hooks M6x12
Screw
washers
( ̛13x̛6x1.2)
Top of
Display *For screen with a hole
pattern in a pocket,spacers
go between Assembly
Adapter Plate and screen. Spacers
Mounting
Screw
M6&M8
Hole
M5 Hole
Square
spacer
Note:
Recessed Mounting Holes.
If the mounting holes are recessed
into the back of the display, use the
supplied spacers to pack the
recessed hole. If the mounting
screw is M5&M6,use the
Spacers1.(K.1.)If the mounting screw
is M8,use the Spacers 2.(K.2.)
Ensure that the brackets are
securely fixed to the display.
For Flat Back Screen
SCREEN
SPACER
SCREEN
fig C.1 fig C.2
SCREW
EE(adapter plate)
OR
Select the small,medium,large or extra large screws from the baffled .Fastener pack then attach
screen brackets(AA) to screen following figure C.1 or C.2 on page 7.
SCREW