Monoprice 4562 Wall Mount Bracket - Manual (Page 2)

Supplied Parts List
Step 1 Mounting the Wall Plate to the Wall
Brick, Solid Concrete and Concrete Block Mounting:
Use the Wall Plate (part 1) as a template to mark 7 hole locations on the wall. Three in the top row of slots, three more in the bottom
row and the last between the top and bottom screws on the left hand side. Make sure these holes are level. Pre-Drill these holes with
a ½” masonry bit to at least 2.5” in depth. Insert a Concrete Anchor (part 8) into each of these holes. Make sure the anchor is seated
completely flush with the concrete surface even if there is a layer of drywall or the other material in front. Attach the Wall Plate to the
wall using 7 Lag Bolts (part 7), as shown in the diagram.
Wood Stud mounting:
The Wall Plate (part a) must be mounted to two wood studs. Use a stud finder to locate two adjacent studs. It is a good idea to verify
where the studs are located with an awl or thin nail. Pre-drill a 2.5” deep hole at the desired height in each stud using a 3/16” drill bit.
Make sure these holes are in the center of the studs and level with each other. Use the Wall Plate as a template to mark the location of
the other holes in each stud. Drill pilot holes at each of the marked locations. Attach the Wall Plate to the wall using the 5 Lag Bolts
(part 7).