BBK Performance 1821 - Manual

INS164
2011 FORD MUSTANG GT 5.0L
85mm THROTTLE BODY
PART# 1821
TOOLS REQUIRED- 8, 10, 13mm sockets, ratchet, 5mm allen wrench.
You will be reusing the stock throttle body gasket.
STEP 1 Disconnect negative battery cable.
STEP 2 Remove strut tower brace.
STEP 3 Remove engine cover by pulling up on it to release it’s mounting pins from the grommets on
the intake manifold. Fig. 1
STEP 4 Disconnect the smaller plastic breather tube from the air inlet tube. You can leave the sound
tube connected. Fig. 2
STEP 5 Loosen the clamps on the air inlet tube at the air box and the throttle body.
STEP 6 Remove air inlet tube and set aside. Fig. 3
STEP 7 Remove the four mounting bolts from the stock throttle body, as you remove the throttle body,
flip it to unplug the motor plug on the bottom. Fig. 4
STEP 8 Wipe off stock rubber throttle body gasket to remove any oil or debris. You will be reusing this
gasket. Fig. 5
STEP 9 Connect motor plug to BBK throttle body and install onto intake manifold. Use supplied bolts
to secure BBK throttle body.
STEP 10 Reinstall the air inlet tube and reconnect breather tube. Tighten clamps. Fig. 6
STEP 11 Reinstall the engine cover’s pins onto the grommets and push down to secure.
STEP 12 Reinstall the strut tower brace and tighten the nuts.
STEP 13 Reconnect negative battery cable.
IMPORTANT- All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.