BBK Performance 25260 - Manual

Gripp Performance Rear Upper
Control Arms
INS-035
Step 1 Carefully place the rear of vehicle on jack stands located at the frame – not the rear axle.
! CAUTION !
Use extreme caution when working under vehicle
Step 2 Using a hydraulic floor jack, raise the rear axle housing under the center section until the axle reaches
approximate ride height. Place jack stands under the axle for safety.
Step 3 Working on one side at a time, remove upper control arm by removing two bolts securing it to the chassis
and rearend housing. Apply a liberal coating of general purpose grease on the new control arm bushings. With
grease Zerk facing the ground reinstall and tighten control arm completely, using a drop of Loc-Tite™ on each
mounting bolt.
Step 4 Follow the same procedure for the other side.
Step 5 You may now lube both grease fittings and reinstall dust caps.
Step 6 Drive the car for approximately 5-10 miles, recheck all nuts and bolts for proper torque specs.
I N S T A L L A T I O N I N S T R U C T I O N S
w w w . B B K P E R F O R M A N C E . c o m
A BBK Company
IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).