BBK Performance 16335 - Manual (Page 2)

STEP 22 Slide the stock barrel clamps onto the front of the stock exhaust system about halfway.
STEP 23 Install the BBK X pipe section into the barrel clamps and then connect the front of the X pipe
to the collectors of the headers. Use supplied nuts and washers to secure.
STEP 24 Level out the X pipe and tighten the collector nuts, then tighten the barrel clamps.
STEP 25 Install the rear O2 sensors into the bungs on the X pipe and connect the O2 sensor extensions.
STEP 26 From the engine compartment, make sure to tighten any header nuts or bolts that you could not
reach from below the car. The front ones are usually easier to tighten from above. Make sure
you tighten the motor mount nuts on the studs that face up. They are easier to get at from the
engine compartment, looking down on them.
STEP 27 Reinstall the air cleaner box.
STEP 28 Reconnect the negative battery cable.
STEP 29 Start engine and check for any exhaust leaks.
STEP 30 Header bolts and nuts should be rechecked after 500 miles or so.
ATTENTION:
Please follow the ECU Relearn procedure on page 6 before
driving on the road.
IMPORTANT- All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle. BBK
Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product
Revised 2/25/2013