BBK Performance 16410 User Manual
Page 2
INS-107
Step 13
Remove motor mount from the engine block.
Step 14
Remove stock exhaust manifold and gasket.
Step 15
Install BBK header and supplied gasket.
Step 16
Insert and finger tighten the supplied collector studs.
Step 17
Re-install motor mount and starter.
Step 18
Lower motor mounts onto their mounting studs and tighten nuts.
Step 19
Re-install the steering shaft.
Step 20
Install matching short X-pipe (BBK 1636 or 1637) using supplied washers, lock washers
and nuts on the collector studs.
Step 21
Install the oxygen sensors into the BBK headers and X-pipe.
Step 22
Install the O2 sensor extensions by plugging them in between the factory wiring harness
connectors and the O2 sensors. If needed, trim the locating tabs off of the O2
sensor extensions with a razor knife or grinder as shown on page 3 .
Step 23
Re-connect negative battery terminal.
Note;
After driving the car for a few hours it’s always a good idea to check and re-
tighten the header bolts.