BBK Performance 16120 User Manual
Page 2
Passenger-Side
Step 14
Unbolt and remove starter from bell housing.
Step 15
Remove motor mount from block if needed.
Step 16
Remove stock exhaust manifold and gasket.
Step 17
Install BBK header and supplied gasket.
Step 18
Insert and finger tighten the supplied collector studs.
Step 19
Re-install motor mount and starter.
Step 20
Lower motor mounts onto their mounting studs
and tighten nuts.
Step 21
Re-install the steering shaft.
Step 22
Re-install H-pipe using supplied washers, lock
washers and nuts at collectors.
Step 23
Re-connect the oxygen sensors.
Step 24
Re-connect negative battery terminal.
After driving the car for a few hours it’s always a good idea to
check and re-tighten the header bolts.
Please visit us at www.BBKPERFORMANCE.com to view a fully photographed
installation of this and the many other BBK products. To maximize your vehicle’s
performance potential we recommend the following BBK PERFORMANCE products:
BBK HI-FLOW X-PIPE
BBK THROTTLE BODY
BBK COLD AIR INDUCTION SYSTEM
BBK PERFORMANCE UNDERDRIVE PULLEYS
INS-098
Remove top nuts.
Removing the oxygen sensor.
Separate H-pipe from tail pipe.
Remove starter.
Remove dipstick tube.
Disconnect steering shaft.