Alliance Laundry Systems CS2000 - Manual (Page 26)

-25-
7. PROBLEMS DURING OPERATION AND START-UP
Problem
Check
--------------------------------------------------------------------------------------------
Cycle does not start
- doors not closed correctly
- emergency stop activated
- contact breaker or
electricity outage
--------------------------------------------------------------------------------------------
Control panel does not
- fuses tripped
light up - emergency stop activated
- processor off
- electricity outage
--------------------------------------------------------------------------------------------
Cycle starts but drum
- fuse of regulator tripped
does not turn - press yellow indicator light
on front side when it is on
--------------------------------------------------------------------------------------------
Cycle starts but water
- water inlet closed
does not enter - pressure switch out of
service
- electronic valve out of
service
- fuse tripped
- electronic valve of inlet out
of service
--------------------------------------------------------------------------------------------
Cycle starts but water
- pressure switch out of
inflow does not stop service
- electronic valve dirty
- tub pressure switch
clogged
- drainage valve still open
--------------------------------------------------------------------------------------------
Cycle starts but heating
- required water level not
does not engage reached
- fuse tripped
- contact coil heating out of
service
- HS probe
--------------------------------------------------------------------------------------------
Heating is on but
- resistor out of service
temperature does not rise