Alliance Laundry Systems CS2000 - Manual (Page 25)

-24-
6. TROUBLESHOOTING
6.1 Checks
• The electrical power supply.
• The protective fuses.
• Water supply interruption.
• Filter
blocking.
• Water pressure failure.
• Waterproofing of the drainage system.
• The driving belts.
• The water levels.
Attention: When the water levels are not correct, consult reseller and replace the
pressure switch.
• When the drainage is obstructed, clean it.
• When the machine vibrates, check the following:
o
It is loaded with a heterogeneous load of laundry.
o
Its load is too small.
o
It is overloaded.
o
Check the condition of the shockbreakers.
o
Check that the lateral frictional gliders exert enough pressure.
• When the machine experiences frequent unbalance problems or when an oil
trace appears on the body of a shockbreaker, the shockbreakers must be
changed.
6.2 Other breakdowns
• When other breakdowns or unusual noises are produced (scrubbing, knocking,
etc.) interrupt work and contact the manufacturer immediately, describing the
problem in detail.