BBK Performance 1737 User Manual
Page 2
Step 15
Re-install the radiator hold down plate and tighten.
Step 16
Starting at the radiator hold down plate, place the supplied rubber sealant strip over the top edges of the shield.
When you get to the corner bend the stripping and continue until you reach the rear mounting tab. Press down on
the stripping firmly to fully engage it’s built in clamp.
Step 17
Re-install the radiator cover. Be sure to guide the front lip of it under the grille before inserting the plunger
fasteners.
Step 18
Re-connect the PCV, mass air meter, and (–) negative battery terminal.
SPECIAL NOTE
Due to the increased airflow and performance gains associated with this product, a slight detonation or lean condition may
occur if used with low octane fuels (Regular). If this happens we recommend switching to a fuel with a higher octane rating
(Premium, or Super).
In addition, if you are installing this product on a vehicle that has been previously modified or has a "tune" other than stock,
you may find it necessary to have the tune adjusted or modified to accommodate for the increase in airflow that this product
provides.
Please visit us at www.BBKPERFORMANCE.com to view a fully photographed installation of this and the many other BBK products available to help maximize
the performance potential of your vehicle.
INS-099
Remove mounting bolt.
Remove mass air meter.