Notice, 7vehicle selection, Erase codes – Actron CP9575 User Manual
Page 7: Mil status

7
Vehicle Selection
Vehicle Selection will be displayed for Read Codes when a manufacturer
specific DTC is retrieved from the vehicle.
Erase Codes
The Erase function performs the following:
9
Erases
Codes (both Confirmed and Pending DTCs).
Permanent codes can only be erased by the vehicle.
9
May erase
Freeze Data results depending on the vehcle.
9
Sets
I/M Monitors to not ready.
Perform Erase Codes function only after systems have
been checked completely and DTCs have been written
down.
To erase codes from the vehicle computer:
1. Set the ignition to Key On and Engine Off. Do NOT start the
vehicle. The engine should not be running.
2. Press and hold the
ERASE key for 3 seconds then release, or
Select Erase Codes from Diagnostic Menu and press
ENTER.
3. When the confirmation message appears on the display, choose
one of the following options.
• To proceed with the operation: Press
ENTER for YES.
• To cancel the operation and return to the Diagnostic Menu:
Press
BACK for NO.
The Tool will automatically perform the Read Codes function after
erasing codes. The Tool will then indicate the number of codes
remaining.
If after erasing codes a DTC returns, the problem has
not been fixed or other faults are present.
MIL Status
MIL (Malfunction Indicator Lamp) status indicates if the vehicle com-
puter is telling the MIL to illuminate when the engine is running.
• MIL ON indicates that the Malfunction Indicator Lamp should
be ON.
• MIL OFF indicates that the Malfunction Indicator Lamp should
be OFF.
NOTICE
NOTICE