Actron CP9575 - Manual (Page 10)

10
• Operation of the keypad to be checked,
• Memory of the Tool to be checked,
• Language to be changed,
• Units of measure to be changed.
State OBD Check (Emissions)
The State OBD Check function is used to display a basic status of the
vehicle’s OBD system.
The State OBD Check function has the following areas:
‰ MIL STATUS ON or OFF
‰ Number of Codes Found
‰ Number of Monitors OK
‰ Number of Monitors Inc
‰ Number of Monitors N/A
9 State OBD Check should be done with the key on engine
running (KOER) due to showing MIL status.
9 The number of codes found are both Confirmed and
Permanent codes. Pending codes are not included.
9 The number of Monitors that are either OK, INC or NA are
only Since DTCs Cleared and not This Drive Cycle.
9 Refer to Read Codes and I/M Monitors for more detailed
information about the results.
View Data
The View Data function allows real time viewing of the vehicle’s
computer module’s PID data. As the computer monitors the vehicle,
information is simultaneously transmitted to the Tool.
View Data allows the following items to be viewed on the Tool:
‰ Sensor data
‰ Operation of switches
‰ Operation of solenoids
‰ Operation of relays
Multiple PIDs may be sent if vehicle is equipped with more than one
computer module (for example a powertrain control module [PCM]
and a transmission control module [TCM]. The Tool identifies them
by their identification names (ID) assigned by manufacturer (i.e. $10
or $1A). See PID Definitions for more information.