Yetter 6300 Coulter Cart - Manual (Page 7)

7
ASSEMBLY INSTRUCTIONS
Attaching the 5” x 5” coulter toolbar to the hanger bar
STEP 3. A coulter will be mounted on the cart directly in line with each opener on the implement that will be
mounted on the cart. Most implements have an even number of openers with no opener in the center,
measure the length of the 5” x 5” toolbar and mark the centerline.
STEP 4. Align the center of the coulter toolbar with the center of the frame. Attach the 5” x 5” toolbar to the
rear of the hanger bar using the offset brackets, ¾” u-bolts, and ¾” lock nuts. Rigidly fasten one bracket
between the toolbar with the rear u-bolt on the center line (on even number of coulters) of the coulter
toolbar. Assemble the four remaining brackets to the toolbar; refer to the illustration below. The location of
the bracket is determined by the width of the toolbar and the row spacing of the implement.
SEE THE FOLLOWING PAGE FOR EXACT BRACKET LOCATIONS