Sper Scientific 800037 WBGT Heat Stress SD Card Logger - Manual (Page 14)

- 14 -
SETUP MODE
2. Press ▲ or ▼ to select yes (touch-tone
enabled) or no (touch-tone disabled).
Press ENTER to save the selection.
Temperature Units
1. Enter the temperature units function
from Setup Mode (see page 11).
“t-CF” appears on the LCD.
2. Press ▲ or ▼ to select C (degrees
Celcius) or F (degrees Farhenheit).
Press ENTER to save the selection.
Sampling Time
The sampling time (seconds) is the time
allotted between successive
measurements. To adjust the sampling
time:
1. Enter the sampling time function from
Setup Mode (see page 11). “SP-t”
appears on the LCD.
2. Press ▲ or ▼ to adjust the value (0, 1,
2, 5, 10, 30, 60, 120, 300, 600, 1800,
3600). Press ENTER to save the
value.
SD Memory Card Format
Enabling this function will format the SD
memory card to work specifically with your
meter. Formatting the SD card will erase
any previous memory on the card. New
SD cards should be formatted to work with
your meter.