Sper Scientific 850024 Hot Wire Anemometer SD Card Logger - Manual (Page 12)

12
SETUP MODE
Auto Power Off
The meter automatically turns off after 10 minutes of
inactivity, however this function can be disabled.
1. Enter the auto power off function from Setup Mode
(see page 10). “PoFF” appears on the LCD.
2. Press ▲ or ▼ to select yes (auto power off enabled)
or no (auto power off disabled). Press ENTER to save
the selection.
Touch-Tone
1. Enter the touch-tone function from Setup Mode
(see page 10). “bEEP” appears on the LCD.
2. Press ▲ or ▼ to select yes (touch-tone enabled) or
no (touch-tone disabled). Press ENTER to save the
selection.
Thermometer Type K/J
1. Enter the thermometer type function from Setup Mode
(see page 10). “tYPE” appears on the LCD.
2. Press ▲ or ▼ to select K or J. Press ENTER to save
the selection.
Temperature Units
1. Enter the temperature units function from Setup Mode
(see page 10). “t-CF” appears on the LCD.