SIGMA PC 15.11 - Manual (Page 27)

61
US/GB
6 TRAINING MODE
6.8 TRAINING vALUES AFTER TRAINING
Prerequisite: You must be in training mode.
After training, you can view the measured values in the training mode
at your leisure. Use the START/STOP, TOGGLE (-) and TOGGLE (+)
buttons to scroll through the individual values. In addition to the current
training values, the heart rate monitor also shows summed values such
as:
k Total time
k Total calories
Note: Total values are available only when the stopwatch is stopped.
6.9 RESETTING ThE TRAINING vALUES
Before you begin a new training session, you should set the training
values to zero as the heart rate monitor will otherwise continue to count
the values. The summed total values for time and calories remain saved.
Prerequisite: You must be in training mode.
Press and hold the START/STOP button. The display
flashes twice and all values are reset. You will then
see the training mode again.