Powerwinch RC 30 - Manual (Page 7)

P OWERWINCH RC 23 & RC30 T RAILER W INCHES
5
Programming a Replacement Remote
1. Connect the 12V power cord to the winch.
2. On the back of the winch, hold the learn switch in
the up position until the winch light comes on (5-20
seconds).
3. Release learn switch.
4. While the winch light is on, push the arrow button on
the remote until the light on the winch flashes 1 time.
5. On the remote, hold the
ON
/
OFF
button until the winch light flashes.
6. Test operation using the procedure given previously.
Remote Operational Notes
 The transmitter (remote) is an electronic device and should be kept dry at all times.
 The remote operates best within a 10'-15' range from the winch (receiver).
Maximum operating distance is 30'-40'. Actual distance may vary depending on
the environment the remote is used in.
 For best operation, hold the remote level with or above the winch.
 The transmitter and receiver have been tested and complies with the limits for a
Class B digital device pursuant to Part 15 of the FCC Rules.
This equipment generates, uses and can radiate radio frequency energy. There is
no guarantee that interference will not occur in any particular installation. This
interference may affect radio and television reception.
 To prevent accidental operation of the winch and to preserve battery life, the
remote must be turned off after every use.
Replacing the Remote Battery
The remote uses a 12V size A23 battery. Batteries are available through your local
battery outlets. For best performance, the battery should be changed every 3 months
or twice during the boating season. Actual battery life is dependent on frequency of
use, environmental conditions and the condition of the remote.
1. Remove the small screw from the back of the remote.
2. Carefully separate the two halves of the remote.
NOTE:
When removing the old battery, make note of the polarity of the
battery. When inserting the new battery, place the negative end
agains the coil spring terminal.
3. ;Remove the old battery and insert the new battery.
4. Reattach the covers and screw removed previously.
Press to Learn
Manual Override
pwRC009