Powerwinch RC 30 - Manual (Page 5)

P OWERWINCH RC 23 & RC30 T RAILER W INCHES
3
I
NSTALLATION
M
OUNTING THE
U
NIT
The following instructions are for standard mounting of the winch. A quick mount
kit is available (p/n P7700000AJ). If installing with the quick mount kit, follow the
directions with the kit. Steps 3, 4 and 6 apply when using the kit.
The winch can be mounted on the trailer in the same position and location as an
existing hand winch.
1. Remove the existing hand winch.
2. Position the unit on the trailer mount stand.
3. Confirm that the winch's cable hook and the bow eye on the boat are at the
same height when the boat is in the fully loaded position on the trailer.
If the bow eye is too high, extra pull is required of the winch and extra stress
is exerted on the boat's stern and bow eye.
If necessary to create equal height, raise or lower the winch stand. In most
cases, trailer manufacturers have adaptors available for use with a winch.
4. Confirm that there is a minimum of 12 inches clearance between the winch
and the bow eye when the boat is in the fully loaded position. If necessary,
extend the bow stop to obtain the clearance.
5. Bolt the unit using a minimum of two (2) 3/8" grade 5 machine bolts and lock
nuts. If the existing mounting holes do not line up with the winch, use the
bottom of the winch as a template and drill two (2) 7/16" holes in the
mounting surface of the trailer stand.
6. If using a double line pull (using a pulley block), install a 3/8" eyebolt on the
stand as close as possible to the base of the winch.
Bow
Eye
Eye Bolt
Pulley Block
Level
12” minimum
pwRC006
A
SSEMBLING THE
P
ULLEY
B
LOCK
1. Place the two screws through one of the teardrop plates
and hold in place.
2. Slide a bushing over each screw.
3. Slide the pulley wheel and hook over the bushings as
shown. The components fit loosely on the bushings.
4. Wrap the cable around the pulley.
5. Place the second tear drop plate over the screws and
secure using the washers and nuts provided.
pwRC014