Mc Leod 1979-04 Mustang Hydraulic Conversion Instructions - Manual (Page 3)

3
Step 5) Screw the McLeod firewall adjuster out until the bullet nose end of the master cylinder contacts
the Teflon pivot in the center of the adjuster. Figure 5
Figure 5
Step 6) Mount the supplied master cylinder fluid reservoir base to the shock tower or other suitable
position. The reservoir must be above the master cylinder. Place the large hose clamp over the bottom of
the reservoir. Press the reservoir onto the base and tighten the clamp. Place the two small hose clamps
onto the red hose and route the red hose from the master cylinder to the reservoir. Tighten the supplied
hose clamps. See Figure 6
Step 7) This step is for the kits that include a slave cylinder. Install the supplied slave cylinder onto the
tab located on the bell housing. Attach the rod to the factory throw out fork. If your kit includes a
hydraulic throw out bearing see enclosed instructions relating to the bearing installation. See Figure 7
Figure 6 Figure 7
Step 8) Connect the AN4 steel braided line from the master cylinder to the slave cylinder. Your vehicle
may be equipped with an Internal or external slave cylinder.
Step 9) Fill the reservoir with DOT 3 or 4 brake fluid (Do not use DOT 5 Fluid). Bleed the system of all
air in the hydraulic lines. Refill the reservoir until it is between the MIN and MAX levels as noted on the
reservoir. The McLeod firewall adjuster is for final adjustment of the clutch engagement.
I0010