Mc Leod 1967-69 Camaro Hydraulic Conversion Instructions User Manual
Page 2
Figure 3
Figure 4
6) Connect the McLeod master cylinder to the slave cylinder with the supplied AN4 line. Fill the
master cylinder with Dot 3 or 4 brake fluid (Do not use synthetic brake fluid!) and bleed system
completely.
7) Adjustments to the pedal height can be made at the rod end attached to the bracket on the brake
pedal. The pedal must travel the full range of motion to allow full clutch release before the pedal
contacts the floor. The push rod must not bottom out into the clutch master cylinder. Be certain
to tighten the rod end jam nut when adjustment is complete.
8) Re-install the brake lines to the brake master cylinder and bleed the brakes.
McLeod Racing, LLC 1600 Sierra Madre Circle Placentia, CA 92870 714.630.3668 Tech Line
See us at
I0012