Mc Leod 1963-1972 Chevelle Hydraulic Conversion Instructions User Manual
Page 2
6) Mount the master cylinder reservoir in a convenient location above the master cylinder using the
supplied screws. Connect the reservoir to the master cylinder with the red hose. Secure the
reservoir and hose with supplied clamps (3). See Figure 2
Figure 3
7) Fill the master cylinder reservoir with Dot 3 or 4 brake fluid (Do not use synthetic brake fluid!).
Before connecting the bottom of the AN4 line to the slave cylinder stroke the pedal a few times to
bleed the upper system. Connect the McLeod master cylinder to the slave cylinder with the
supplied AN4 line and bleed system completely.
8) Adjustments to the pedal height can be made at the rod end attached to the bracket on the brake
pedal. The pedal must travel the full range of motion to allow full clutch release before the pedal
contacts the floor. The push rod must not bottom out into the clutch master cylinder. Be certain
to tighten the rod end jam nut when adjustment is complete.
9) Re-install the brake lines to the brake master cylinder and bleed the brakes.
McLeod Racing, LLC 1600 Sierra Madre Circle Placentia, CA 92870 714.630.3668 Tech Line
See us at
I0033.1