Mc Leod 1970-1981 Camaro Hydraulic Conversion Instructions User Manual
Page 2
5) Both pedals should now be securely mounted and travel through their complete arc. Be sure to
install the rubber pedal covers at this time. See Fig 3
6) Assemble the McLeod master cylinder to the mounting plate with supplied screws and lock
washers. Tighten screws securely. Install the mounting plate/McLeod master cylinder assembly,
passing the pushrod through the firewall. Re-install the factory brake master cylinder onto the
mounting bracket. Install washers and nuts. Tighten all four fasteners securely.
7) Assemble the rod end attached to the push rod to the new pedal hole location with the supplied
hardware in this order from right to left……bolt, pedal, two flat washers, rod end, flat washer and
nut. Tighten nut securely. Do not reinstall the heavy pedal return spring to the pedal if present.
Swing the pedal through its range of motion to be certain there is no interference with any
component including wires and or hoses. See Figure 5.
8) Mount the master cylinder reservoir in a convenient location above the master cylinder using the
supplied screws. Connect the reservoir to the master cylinder with the red hose. Secure the
reservoir and hose with supplied clamps (3). See Figure 2
Figure 5
9) Fill the master cylinder reservoir with Dot 3 or 4 brake fluid (Do not use synthetic brake fluid!).
Before connecting the bottom of the AN4 line to the slave cylinder, insert the end of the line into
the top of the reservoir or a container, stroke the pedal a few times to bleed the upper system.
When no air bubbles appear, connect the McLeod master cylinder to the slave cylinder with the
supplied AN4 line and bleed system completely.
10) Adjustments to the pedal height can be made at the rod end attached to the bracket on the brake
pedal. The pedal must travel the full range of motion to allow full clutch release before the pedal
contacts the floor. The push rod must not bottom out into the clutch master cylinder. Be certain
to tighten the rod end jam nut when adjustment is complete.
11) Re-install the brake lines to the brake master cylinder and bleed the brakes.
McLeod Racing, LLC 1600 Sierra Madre Circle Placentia, CA 92870 714.630.2764 Tech Line
See us at
I0031.1