MBRP S6050 - Manual (Page 4)

S6150 © 2/13 PAGE 4 OF 5
Figure 10
2. Loosely secure the Down Pipe to the exhaust manifold with the hex bolt
from the stock down pipe. Finish tightening the V-Band at the turbo and then
finish tightening the bolt on the exhaust manifold. Refer to Figure 10.
3. Install the stock sensors into the Down Pipe. One is located along the lower
section of the Down Pipe (Refer to Figure 11.) The other two sensors are
located closer to the turbo. The front pipe can then be reinstalled using the
stock hardware and V-Band clamp. Refer to Figures 10 & 11.
4. Reinstall the exhaust hanger to the transmission cross member. Reinstall the
transmission cross member. Reconnect all the sensors to the front pipe.
Reinstall the passenger side inner fender.
5. Reinstall the turbo heat shield. Refer to Figure 13. Check along the exhaust
to make sure all connections and tightened and sensors are reconnected.
Figure 11
Figure 12
Figure 13
V-Band Clamp