King of Fans Fulton - Manual (Page 11)

Installing the Light Kit
/ Glass Bowl
CAUTION- To reduce the risk of
electrical shock, disconnect the electrical
supply circuit to the fan before installing
light kit .
1. Remove the three mounting screws
and lockwashers on the black bracket
below the fan motor (Figure 13).
2. Connect the Blue wire from the fan
motor to the Black wire from the light kit
assembly by connecting the molded
adaptor plug; connect the White wire
from the fan motor to the White wire
from the light kit assembly by
connecting the molded adaptor plug.
3. Secure the light kit assembly to the
black bracket using the three screws and
lockwashers that were removed in step 1.
4. Remove the three mounting screws on
the side of the light kit assembly (Figure
14)
5. With power off, install the circline
lamp (Max. 30W, provided) to the lamp
bracket pre-assembled in the light kit
assembly and engage the connector from
the ballast of the light kit assembly
with the 4-pins on the circline lamp ,
make sure they are engaged properly
(Figure 14).
6. Install the glass bowl to the light kit
assembly and finger tighten with three
mounting screws that were removed in
step 4.
8