King of Fans Fulton - Manual (Page 10)

Attaching the Fan
Blades
NOTE: Your fan blades are reversible,
select the blade side finish which best
accentuates your decor.
1. Attach the blade accent to the blade
tip by using the screws supplied (Figure
10).
2. Attach blade to blade bracket, using
the washer head screws supplied (Figure
10). Please note that the rubber washers
are pre-attached to the blade bracket.
Start a screw into the bracket. Repeat for
the two remaining screws.
3. Tighten each screw securely.
4. Insert the blade assembly through
the slot cut-out in the center flywheel,
align the two screw holes in the blade
bracket with the screw holes in the
flywheel and secure with screws and
lockwashers provided (Figure 11).
5. Repeat steps 1, 2, 3 & 4 for the
remaining blades.
All blades are grouped by weight.
Because natural woods vary in density,
the fan may wobble even though the
blades are weight matched.
The following procedure should correct
most fan wobble. Check after each step.
1. Check that all blade and blade
bracket screws are secure.
2. Most fan wobble problems are
caused when blade levels are unequal.
Check this level by selecting a point on
the ceiling above the tip of one of the
blades. Measure from a point on the
center of each blade to the point on the
ceiling. Measure this distance as shown
in Figure 12. Rotate the fan until the next
blade is positioned for measurement.
Repeat for each blade. Measurements
deviation should be within 1/8". Run the
fan for 10 minutes.
3. Use the enclosed Blade Balancing
Kit if the blade wobble is still noticeable.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT
FOREIGN OBJECTS BETWEEN ROTATING FAN
BLADES.
7
Touching
ceiling