Jesel INS-30260 Zero Thrust Cam Adapter - Manual

Zero Thrust Cam Adaptor
KCA-39260. SB Chevrolet (ADP-30260)
KCA-39290, BB Chevrolet (ADP-30290)
INS - 30260
JESEL, INC
1985 CEDAR BRIDGE AVE
SUITE 2
LAKEWOOD, NJ 08701
732-901-1800, FAX 732-901-6777
www.jesel.com
THIS INSTRUCTION SHEET IS INTENDED AS REPRESENTATION ONLY. JESEL IS IN NO EVENT LIABLE FOR CONSEQUENTIAL DAMAGE,
INSTALLATION COST OR OTHER COST OF ANY NATURE. NO REPRESENTATIVE IS AUTHORIZED TO ASSUME FOR JESEL ANY OTHER
LIABILITY IN CONNECTION WITH ANY JESEL PRODUCT. NOT RESPONSIBLE FOR TYPOGRAPHICAL ERRORS.
IF NEEDED, DOUBLE-DISC GROUND THRUST
WASHERS ARE AVAILABLE TO ADJUST
CAMSHAFT END PLAY.
JESEL ZERO-THRUST CAM ADAPTER IS DESIGNED
TO ELIMINATE LIFTER DAMAGING CAMSHAFT
ENDPLAY. THIS ADAPTER IS MANUFACTURED FROM
A HEAT TREATED TOOL STEEL AND IS SILVER IN
COLOR. THE CYLINDER BLOCK MUST BE MACHINED
TO RUN THIS ADAPTER. THE CAMSHAFT ENDPLAY
CAN BE RUN AS TIGHT AT .001”.
THE CAM TUNNEL MUST BE MACHINED 3.000”
DIAMETER x .070” DEEP TO ACCEPT THE REAR
TORRINGTON BEARING AND WASHER.
02/14
WSH-30810-25 3.000” OD X 2.250” ID X .025”
WSH-30810-27 3.000” OD X 2.250” ID X .027”
WSH-30810-29 3.000” OD X 2.250” ID X .029”