Jesel INS-SS0001 Chevy BB Sportsman Series Rockers - Manual

Instruction Sheet
Chevrolet BB
Sportsman Series Rockers
INS-SS0001
1985 Cedarbridge Ave
Lakewood, NJ 08701
732-901-1800
VALVETRAIN INNOVATION
STEP 1: STARTING AT #1 CYL, PLACE STAND
LINK ON INTAKE AND EXHAUST STUD BOSS.
USE SUPPLIED SUPPORT WASHERS IF NEEDED
TO SUPPORT STAND LINK. STAND LINK MAY BE
ADJUSTED SLIGHTLY IF NEEDED FOR IMPROVED
STAND ENGAGEMENT.
STEP 2: LOCATE INTAKE STAND NEEDED FROM
CHART ON BACK PAGE. USE LONGEST BOLT
POSSIBLE AND INSTALL USING THREAD SEALANT.
DO NOT TORQUE STAND BOLT AT THIS TIME.
STEP 3: LOCATE EXHAUST STAND NEEDED
FROM CHART ON BACK PAGE. USE LONGEST
BOLT POSSIBLE AND INSTALL USING ENGINE
OIL ON THREADS. CHECK TO MAKE SURE BOTH
STANDS ARE ENGAGED INTO STAND LINK AND
TORQUE BOLTS TO SPECS ON BACK PAGE.
STEP 4: USING AVAILABLE ADJUSTABLE
PUSHROD (TOL-29400), CHECK FOR PUSHROD TO
HEAD INTERFERENCE AND CORRECT IF NEEDED.
MEASURE FOR PROPER LENGTH PUSHRODS
FOLLOWING INSTRUCTIONS INCLUDED WITH
ADJUSTABLE PUSHROD TOOL.
STEP 5: WITH THE LIFTER ON ITS BASE CIRCLE,
PLACE THE CORRECT LENGTH PUSHROD INTO
POSITION. APPLY SUPPLIED ASSEMBLY LUBE TO
PUSHROD TIP AND BOLT ROCKER TO STAND.
STEP 6: TORQUE ROCKER SHAFT BOLTS TO
SPECS ON BACK PAGE. ROTATE ENGINE 90° AND
REPEAT STEPS 5 & 6 FOR REMAINING CYLINDERS
FOLLOWING ENGINES FIRING ORDER.