Innovate Motorsports LC-1 - Manual (Page 13)

- 13 -
On this page you can see the software version of the LC-1 and you can change the multiplier to
calculate AFR from Lambda. A number of different multipliers are already pre-selectable but you
can change it to a custom one for the particular fuel you are using.
If you plan to use multiple LC-1’s, change the device name to something identifying which LC-1 is
connected where. For example LC1-Cyl1 for a LC1 connected to Cylinder 1. The device name
can be up to 8 characters long.
6.3 Resetting the calibration data
Press the Reset Calibration button if you want to reset all calibration data in the LC-1.
This will clear all calibration data of the LC-1.
6.4 Updating the Firmware
The LM Programmer Info/Set AFR tab reports the firmware version currently installed on your
unit. Do not update the firmware if the versions are the same. A firmware update should only be
necessary if there has been a new release.
Click the 'Update Firmware' in the main page to upgrade to the latest firmware for the LC-1.
Firmware for the LC-1 has the extension dld. New firmware releases are available on the
Innovate Motorsports’ web site (www.tuneyourengine.com) under ‘Support.’
If your computer crashes during a firmware upgrade, the LC-1 has a recovery mechanism where
it will be able to retry the download again and not be disabled by half loaded firmware. Switch the
LC-1 off and on again and then try to restart the LC1 Manager software. The recovery
mechanism is designed to be able to recover 99.9% of the time. While we don’t anticipate this
occurring, it is possible that the LC-1 will not recover correctly and may need to be serviced at
our factory. If you suspect this is the case, contact Innovate support.