Innovate Motorsports LC-1 - Manual (Page 12)

- 12 -
6 Programming the LC-1
The LC-1 is programmable with the following functionality:
1. Change the relationship between Lambda and AFR.
2. Upgrade and change the software.
3. Change the output characteristics of the Analog outputs.
Avoid connecting or disconnecting any of the ports labeled IN or OUT while
the unit is powered ON.
6.1 Installing the LM Programmer Software
Put the included CD in your CD-drive on your computer and follow the instructions on screen.
The Software will be installed including pre-set directories for log-data and downloaded software.
The LM Installer also puts entries for the LM Software in the Start-Menu of your computer under
the heading ‘LogWorks2’.
6.2 Hooking up the LC-1 device to the computer
1. Connect the Serial OUT connection with the included 2.5mm stereo to DB-9 cable to a serial
port on your laptop.
2. Connect the terminator plug (2.5mm male plug with no cable) into the Serial IN connection of
the LC-1.
Start the LM-Programmer software. The screen should look like this: