Avocent PS/2 KVM - Manual (Page 32)

Single port PS2 KVM over IP
Figure 5.12: PS/2 KVM over IP switch network settings
. IP auto configuration
With this option you can control if PS/2 KVM over IP switch should fetch its network settings from
a DHCP or BOOTP server. For DHCP you have to enter dhcp and for BOOTP supply bootp
accordingly. If you specify none then IP autoconfiguration is disabled.
. IP address
IP address in the usual dot notation.
. Subnet mask
The net mask of the local network.
. Gateway IP address
In case the PS/2 KVM over IP switch should be accessible from networks other than the local
one, this IP address must be set to the local network router’s IP address.
. Primary DNS Server IP address
IP address of the primary Domain Name Server in dot notation. This option may be left empty;
however PS/2 KVM over IP switch won’t be able to perform name resolution.
. Secondary DNS Server IP address
IP address of the secondary Domain Name Server in dot notation. It will be used in case the
Primary DNS Server can’t be contacted.
. Remote Console & HTTPS port