Demon Fuel Systems 1905 - Manual (Page 6)

6
NOTE: If this carburetor is to be used in an application utilizing an electronic transmission that requires a
throttle position sensor signal to operate properly, Demon has you covered. Part # 1951 (Street
Demon
™ TPS kit) is designed to bolt directly to your new Street Demon™ carburetor to provide the
needed TPS signal to an electronic transmission. Consult the installation manual for the 1951 Street
Demon TPS kit for installation and adjustment instructions.
Ford Kick-Down Linkage
All
Street Demon™ Carburetors come with a Ford kick-down linkage. If running a Ford automatic and the kickdown
linkage is needed, a spring and perch kit (Part # 1954) is required.
NOTE:
Street Demon™ Carburetors will not work with a Ford AOD transmission.
1. Press the screw retainer into position (Fig. 3).
2. Remove shipping screw (Fig. 4).
3. Install adjustment screw and locknut (Fig. 5). Consult the Ford Service Manual for proper setting.
4. Install the mounting bracket and return spring (Fig. 6).
Figure 3 Figure 4
Figure 5 Figure 6
WARNING:
Install the transmission kickdown adjustment screw retainer, adjustment screw, and locknut, as
correctly indicated. Failure to attend to this detail may result in a sticking wide-open throttle or
dangerous uncontrolled engine speed.