Demon Fuel Systems 1905 - Manual (Page 3)

3
If you experience any installation questions, problems, or issues, please contact our technical service
department between the hours of 8AM and 5PM CST M-F @ 1-270-901-3346.
DO NOT RETURN TO THE PLACE OF PURCHASE, unless instructed to do so by technical service.
Recommended Parts and Accessories
Part Number Description
1931 Street Demon ™ calibration kit
1950 Idle kick-up solenoid and bracket
1951 Street Demon ™ TPS kit (for use with electronic transmissions requiring a TPS signal)
1952 GM throttle linkage cable attachment bracket
1953 Throttle cable and transmission kickdown bracket
1954 Ford kickdown spring and perch kit
1958 Billet Throttle Cable Bracket
1959 Billet Detent Bracket for 1958 Throttle Cable Bracket
160049 Universal carburetor installation kit
124007 Chrysler throttle stud
786004 Demon chrome 14” air cleaner assembly
1919 Street Demon ™ rebuild kit
Removal of Existing Carburetor
1. Remove the air cleaner, exercising care to carefully detach any vacuum lines from the air cleaner and marking them
so they can be reassembled to the air cleaner in the same manner.
2. Remove the existing carburetor by the following procedure:
A. Carefully disconnect the fuel line.
WARNING:
Carefully protect the open end of the fuel lines, so that no foreign particles can enter. Wrap the
end of the fuel line with a clean lint-free cloth.
B. Disconnect and mark all vacuum lines and wiring (if any) to the carburetor.
C. Disconnect the PCV hose.
D. Disconnect the choke rod or heat tubes (if equipped).
E. Disconnect and remove the throttle linkage and automatic kickdown linkage. Save all retaining clips.
F. Unbolt and remove the carburetor from the manifold.
3. If the intake manifold is being changed at this time, install the new manifold according to the manifold manufacturer ’s
directions.