American Fibertek Scout SS1 User Manual
Page 9
9
Front Panel
Power: There are two power indicators, one for power supply and one for power status. The
power LED illuminates green when power is applied. The status LED is green for normal
operation and will turn red for alarm conditions on any of the internal temperature monitors or
power supply voltage monitors.
10/100 base T Ethernet Ports:
Link Off
–
No
connection
Amber - 10 Mb/s
Green - 100 Mb/s
Act
Off – No data activity
Amber Flashing – Data activity
Alarm In: Alarm contact LED’s are per “current status”.
Normal condition - LED is off
Alarm condition - LED will be Red
Auxiliary out: Auxiliary contact LED’s are per “current status”.
Normal condition - LED is off
Alarm condition (Relay Activated) - LED will be Red
Port LEDs RS232 & RS485:
There is one Bicolor LED per port. (Port A = RS232, Port B
= RS485.) When Tx is active the LED will turn Red for 0.25 seconds. When the Rx is
active the LED will turn Green for 0.25 seconds.
Rx: = Data from TCP to Serial
Tx: = Data from Serial to TCP
In the event the network has a duplicate IP address on the same LAN, Port A will flash amber as
long as the condition exists. Scout will check this network condition each minute.
When the condition is no longer present the LED will turn off. When multiple Scouts or Scouts
are operating on the same network, all units will show this condition.