Inst – Anetsberger Brothers SLG40 User Manual

Page 8

CASTER LEVELING INSTRUC-
TIONS

1. Move the fryer to its desired location.

2. Determine whether the fryer tends to wobble

or rock when in its desired location. If it
does, perform steps 3 through 9. If it does
not, skip to step 10, then proceed to the
Installation Instructions.

WARNING

The fryer MUST NOT tip, rock or wob-
ble, to avoid splashing or spilling its HOT
shortening contents during operation.

3. Determine which caster requires adjustment

and the approximate amount of change
required to level the fryer.

4. Position the side of the fryer on the ship-

ping carton, exposing the bottom of the fryer
(Figure 5).

5. Completely remove the bolts holding the

caster mounting plate that requires leveling
adjustment. Retain the bolts for later
reassembly.

INST

INSTALLA

ALLA

ALLATION REQ

TION REQ

TION REQUIREMENTS

UIREMENTS

(Continued)

Figure 4. Typical Caster Installation

CASTER INSTALLATION
INSTRUCTIONS

1. Flatten the shipping carton (after unpacking the

fryer and its parts and accessories) for surface
protection during caster installation.

2. Position the side of the fryer flat on the carton,

exposing the fryer bottom mounting brackets
for caster installation, as shown in Figure 4.

3. Mount locking casters on the front of the fryer

and fixed casters on the rear, by placing each
caster mounting plate on the fryer bottom.

4. Insert one mounting bolt through the proper

hole in the caster mounting plate and start it
into the proper hole in the fryer mounting
bracket.

5. Screw a locking nut several turns onto the

mounting bolt.

6. Repeat steps 4 and 5 until all four mounting

bolts for each leg are in place with locking nuts.

7. Tighten the four bolts evenly and

securely to hold the caster mounting plate
against the bottom of the fryer.