Brewer Element Treatment 2030/2040 User Manual

Page 2

Document 101290 RevA

MODELS 2030 & 2040

For the above models you will receive
two separate cartons: a frame carton,
and an upholstery carton. Inspect both
carefully for shipping incurred damage.

COMPONENT IDENTIFICATION

Perform the following sequence in order when setting up

the table:

Unpacking

Assembly

Leveling the Table

Installing the Paper Roll

NOTE: Inspect all boxes and contents for damage.

Report any damage to the carrier immediately.

OVERVIEW

COMPONENT IDENTIFICATION

MODELS 2030 and 2040 HARDWARE

NOTE: Save all packaging in case re-shipment is re-

quired.

1/4”-20 x 4” Screw A (Qty. 1)

1/4”-20 x 2” Screw B (Qty. 3)

(Painted)

1/4”-20 x 1 1/4” Screw C (Qty. 8)

Cotter Pin (Qty. 2)

Bumper (Qty. 2)

J-Bolt R (Qty. 2)

3/8” Nut L (Qty. 2)

Washer M (Qty. 2)

10-24 x 1 1/4” Screw D (Qty. 2)

Cap (Qty. 2)

1/4”-20 x 1” Screw F (Qty. 8)

1/4”-20 x 1/2” Screw G (Qty. 5)

Clevis Pin (Qty. 2)

1/4”-20 Nut H (Qty. 6)

Allen Wrench (Qty. 1)

Rubber Mallet 9/16” Open End Wrench

Phillips Screw Driver 7/16” Socket or Wrench

Snap Rivet (Qty. 2)

CAUTION

To avoid damaging the table’s upholstery or

painted surfaces, DO NOT use a knife or any other

sharp object to open the packaging.

WARNING

Two or more people should assist in moving the table.

Use proper lifting techniques when lifting. Failure to

do so could result in serious injury!

MODELS 2030 and 2040 TOOLS NEEDED