GE JM250DFBB - Manual (Page 18)

18
49-80696-1
CARE AND CLE
ANING:
Maintenance
Maintenance
SHOCK OR BURN HAZARD: %HIRUHUHSODFLQJRYHQOLJKWEXOEGLVFRQQHFWWKHHOHFWULFDO
power to the range at the main fuse or circuit breaker panel. Failure to do so may result
in electric shock or burn.
WARNING
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot
glass with bare hands or a damp cloth can cause burns.
CAUTION
Oven Light Replacement
To remove:
1. Hold a hand under the cover so it doesn’t fall when
released. With fingers of the same hand, firmly push
back the wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
2. Replace bulb with a 40-watt appliance bulb.
To replace:
1. Place it into groove of the light receptacle. Pull wire
forward to the center of the cover until it snaps into
place.
2. Reconnect electrical power to the oven.
Lift-Off Oven Door
7KHGRRULVYHU\KHDY\%HFDUHIXOZKHQUHPRYLQJDQGOLIWLQJWKHGRRU
Do not lift the door by the handle.
To remove the door:
Open it to the broil stop position. Grasp firmly on each
side and lift the door straight up and off the hinges.
Do not place hands between the hinge and the oven
door frame.
To replace the door:
Make sure the hinges are in the broil stop position.
Position the slots in the bottom of the door squarely over
the hinges and slowly lower it over both hinges.
To clean the inside of the door:
Ŷ %HFDXVHWKHDUHDLQVLGHWKHJDVNHWLVFOHDQHGGXULQJ
the self-clean cycle, you do not need to clean this by
hand.
Ŷ 7KHDUHDRXWVLGHWKHJDVNHWDQGWKHIURQWIUDPHFDQ
be cleaned with a soap-filled steel wool or plastic pad,
hot water and detergent. Rinse well with a vinegar
and water solution.
To clean the outside of the door:
Ŷ 8VHVRDSDQGZDWHUWRWKRURXJKO\FOHDQWKHWRS
sides and front of the oven door. Rinse well. You may
also use a glass cleaner to clean the glass on the
outside of the door. Do not let water drip into the vent
openings.
Ŷ 6SLOODJHRIPDULQDGHVIUXLWMXLFHVWRPDWRVDXFHV
and basting materials containing acids may cause
discoloration and should be wiped up immediately.
When surface is cool, clean and rinse.
Ŷ 'RQRWXVHRYHQFOHDQHUVFOHDQLQJSRZGHUVRUKDUVK
abrasives on the outside of the door.
Wire cover holder.
(appearance may vary)
The gasket is designed with a gap
at the bottom to allow for proper air circulation.
'RQRWUXERUFOHDQWKHGRRUJDVNHW³LWKDVDQ
extremely low resistance to abrasion.
If you notice the gasket becoming worn, frayed or
damaged in any way or if it has become displaced on
the door, you should have it replaced.
Lift the door straight up and off the hinges.