Agri-Fab 175 LB. ATV BROADCAST SPREADER 45-03295 - Manual (Page 6)

6
ENGLISH
16. Calibrate the flow control setting. (See figure 9).
a. Push flow control arm to "OFF" position.
b. Slide flow control mounting bracket along tube until
closure plate in bottom of hopper just closes.
c. Snug the 1/4" nylock hex nuts just enough to hold
flow control mounting bracket in place.
d. Set adjustable stop at "5". Pull flow control arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, adjust
position of flow control mounting bracket until
closure plate will open about half way at "5" and
will still close when arm is locked in "OFF" position.
Tighten the 5/16" nylock hex nuts.
FIGURE 9
FLOW
CONTROL
ARM
OFF
ON
1
2
3
4
6
7
8
9
10
5
ADJUSTABLE
STOP
(SETTING "5")
ON
OFF
0
OFF
ON
1 2 3 4 6 7 8 9 10
5
(B) 1/4" x 1-3/4"
HEX BOLT
(C) 1/4" NYLOCK
HEX NUT
HITCH BRACE
(INNER)
FLOW CONTROL
MOUNTING TUBE
HITCH BRACE
(INNER)
FIGURE 8
14. Assemble the two INNER hitch braces to the flow control
mounting tube using a 1/4" x 1-3/4" hex bolt (B) and a
1/4" nylock hex nut (C).
DO NOT TIGHTEN YET. See
figure 8.
15. TIGHTEN all nuts and bolts assembled up to this point.
Do not collapse the tubes when tightening.