Agri-Fab 175 LB. ATV BROADCAST SPREADER 45-03295 - Manual (Page 5)

5
FIGURE 4
13. Assemble the flow control mounting tube to the hitch tube
using two 5/16" x 1-3/4" hex bolts (A) and 5/16" nylock
hex nuts (D).
DO NOT TIGHTEN YET. See figure 7.
FIGURE 7
7. Assemble a spacer (I), a 3/4" flat washer (G), a wheel
(air valve facing out) and another 3/4" flat washer (G)
onto the end of the axle that has both the
large and
small holes. See figure 4.
8. Install a 1/8" x 1-1/2" cotter pin (E) into the small hole
in the end of the axle. See figure 4.
9. Open the bail on the drive pin (J) and install it through
the wheel and the large hole in the axle. Close the bail
to lock the pin in place. See figure 4.
(J) DRIVE PIN
AIR VALVE
(I) SPACER
(G) 3/4" FLAT
WASHER
(E) 1/8" x 1-1/2"
COTTER PIN
ENGLISH
12. Insert the hook end of the flow control rod through the
hole in the slide gate bracket located under the hopper.
See figure 6.
FIGURE 5
(A) 5/16" x 1-3/4"
HEX BOLT
(D) 5/16" NYLOCK
HEX NUT
OFF
ON
1 2 3 4 6 7 8 9 10
5
FLOW CONTROL
MOUNTING TUBE
HOPPER
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
OFF
ON
1 2 3 4 6 7 8 9 10
5
FLOW
CONTROL
ROD
10. Turn the spreader upright on its wheels.
11. Insert the pinched end of the flow control rod through
the hole in the in the flow control arm. See figure 5.
FIGURE 6